Electrical and related buildings technology
Cable insulation is used to provide electrical separation between conductors of a cable. During the historical development of cables, numerous types...
In the previous note we looked at the approach taken by the standard to the sizing of cables and illustrated this with an example. We then looked at one...
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
Current transformers (CTs) are used to convert high level currents to a smaller more reasonable level for use as inputs to protection relays and metering...
Various techniques exist to enable the correct selection of batteries for UPS applications. The procedure described below is one of the more common. ...
IEC 60287 "Calculation of the continuous current rating of cables (100% load factor)" is the International Standard which defines the procedures and equations...
Most installations involve some form of lightning protection system which is connected to an earth electrode. The function of the earth electrode is to...
I was digging in my bookshelf and came across the 80th Anniversary Association of Mine Resident Engineers, Papers and Discussions Commemorative Edition...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.