Electrical equipment - design, use and implementation
I'm a fan of using manufacturers catalogues. There are two main reasons for this. Firstly, if your involved in the purchase of equipment, you will likely...
Various arguments exist around SF6 Gas Insulated (GIS) and Air Insulated (AIS) medium voltage switchgear. Recently we had to change a GIS design to AI...
Over the past year or so I've been involved in on going discussions related to referring fault levels from the secondary of a transformer to the primary...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
Our cable sizing tool is one of the more popular tools on the site. The tool enables cables to be sized in compliance with BS 7671 (the IEE Wiring Regulations...
Fire resistant and fire retardant cable sheaths are design to resist combustion and limit the propagation of flames. Low smokes cables have a sheath designed...
Have an opinion or something to say, want to ask or answer questions, share your knowledge then use our site to do it . As a community of people interested...
The IEC publishes a series of documents and rules governing the preparation of documents, drawings and the referencing of equipment. Depending on country...
While not as popular as it once was, frame leakage protection does still have some use in some circumstances. In essence frame leakage is an earth fault...
IEC 60287 "Calculation of the continuous current rating of cables (100% load factor)" is the International Standard which defines the procedures and equations...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.