Electrical equipment - design, use and implementation
IEC 60287 "Calculation of the continuous current rating of cables (100% load factor)" is the International Standard which defines the procedures and equations...
Years ago I was told that you should always try to write the best report you can. Many years later I still think on this as one of the better pieces of...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
Light Emitting Diodes (LED ) are increasing gaining favour in both the domestic and commercial sectors; due to their efficiency, sustainability and durability...
Fault calculations are one of the most common types of calculation carried out during the design and analysis of electrical systems. These calculations...
A UPS is an uninterruptible power supply. It is a device which maintains a continuous supply of electrical power, even in the event of failure of the...
Using software in our work is essential for most of us and we are becoming even more dependant on it's use. While software is a great asset, many times...
A fundamental concept behind the operation of alternating current systems is that voltage and current waveforms will be sinusoidal – a Sine Wave. This...
I have been thinking recently that there appears to be less professional integrity around than when I first started my career in electrical engineering...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.