One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
If you at all familiar with programs like office and outlook, then adding and editing posts is pretty straightforward and intuitive. However, there are...
Multimeters are undoubtedly the most common item of electrical test equipment in use. Often it is the first piece of equipment people will turn to when...
The 27 km, Euro 6 billion Collider lies on the border between France and Switzerland, took nearly 30 years to complete. Some of the lofty goals for the...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
"I can live with doubt and uncertainty and not knowing. I think it is much more interesting to live not knowing than to have answers that might be wrong...
A recurring theme on our forums is cable sizing. Now many installations are unique and require special consideration. However, a lot of the time things...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.