Induction motors are frequently used in both industrial and domestic applications. Within the induction motor, an electrical current in the rotor is induced...
Cable insulation is used to provide electrical separation between conductors of a cable. During the historical development of cables, numerous types...
IEC 61439 'Low-voltage switchgear and controlgear assemblies', specifies standard arrangements of switchboard (call forms of internal separation). The...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
We have had the Wiki with us for a long time now, but at last I have decided to say bye bye – more details on why below.
Everything physical in electrical engineering from insulations to conductors revolves around materials. Here we are listing common materials along with...
This morning I was explaining how differential protection works to a junior engineer. To give him something to read I opened up the NPAG (Network Protection...
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
Power cables can basically be classified into earthed and unearthed cables, where earthed and unearthed refer to the application for which the cable is...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.