Resistors are electronic components that oppose the flow of current. Manufactured in various types and ranges they have a wide application to electronics...
From the earliest times, humans have found ways to create light. Pre-historic peoples used natural materials (moss, grass, etc.) soaked in animal fat and...
Carrying out a protection system discrimination study is critical to ensure the correct functioning of the electrical system in the event of faults. ...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
Current transformers (CTs) are used to convert high level currents to a smaller more reasonable level for use as inputs to protection relays and metering...
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
I'm a fan of using manufacturers catalogues. There are two main reasons for this. Firstly, if your involved in the purchase of equipment, you will likely...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
I've recently come across this question a couple times browsing the internet. Decided to give a quick answer here. A rectifier transformer is a transformer...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.