A UPS is an uninterruptible power supply. It is a device which maintains a continuous supply of electrical power, even in the event of failure of the...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
A load flow study is the analysis of an electrical network carried out by an electrical engineer. The purpose is to understand how power flows around...
IEC 62305 'Protection against lightning' requires a risk assessment be carried out to determine the characteristics of any lightning protection system...
One of the requirements to ensuring that everything works is to have equipment selected, manufactured and verified [tested] to IEC standards. Not all equipment...
The standard aims to consolidate AC and traction voltages within the industry and defines the following bands: band 1 - A.C. systems 100 V to 1...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...
The other day I was reading 'Night of the New Magicians' by Mary Pope Osborn with my son. The story is about a young boy and girl who travel back in time...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.