Fundamental electrical engineering concepts and theory
Earthing of electrical systems is essential for the correct functioning and the protecting of life and equipment in the event of faults. The earth electrode...
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
Just added a page to the tools, which will allow you to calculate the synchronous speed, slip and rated torque for an induction motor. Not a particularly...
A load flow study is the analysis of an electrical network carried out by an electrical engineer. The purpose is to understand how power flows around...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
Our cable sizing tool is one of the more popular tools on the site. The tool enables cables to be sized in compliance with BS 7671 (the IEE Wiring Regulations...
Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...
Traditionally substations have used circuit breakers, current transformers (CT), voltage transformers (VT) and protection relays all wired together using...
Current transformers (CTs) are used to convert high level currents to a smaller more reasonable level for use as inputs to protection relays and metering...
A quick post in connection with an email question: Live Tank - the circuit breaker the switching unit is located in an insulator bushing which is live...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.