Fundamental electrical engineering concepts and theory
In an earlier note on the site [Photovoltaic (PV) - Electrical Calculations], the theory of solar (PV) cell calculations was introduced. In particular...
A UPS is an uninterruptible power supply. It is a device which maintains a continuous supply of electrical power, even in the event of failure of the...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
If you are working on a large plan, get the real coordinates [latitude, longitude] for two or more points and add them to the drawing. That way you can...
Various techniques exist to enable the correct selection of batteries for UPS applications. The procedure described below is one of the more common. ...
Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
Exposure to time varying magnetic fields, from power frequencies to the gigahertz range can have harmful consequences. A lot of research has been conducted...
myElectrical does not support or promote the use of copyrighted material without the copyright owner's consent. If you believe that material for which...
I've been considering a blog on the 110 or 230 Volt issue for a while. While browsing the Internet I came across a great summary by Borat over at engineering...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.