Fundamental electrical engineering concepts and theory
When selecting a generator, there are inherent limits on the active and reactive power which can be delivered. Generators are normally sized for a certain...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
A single phase system is perhaps the most common type of system most people are familiar with. This is what people have in their homes and what appliances...
Using software in our work is essential for most of us and we are becoming even more dependant on it's use. While software is a great asset, many times...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
Power cables can basically be classified into earthed and unearthed cables, where earthed and unearthed refer to the application for which the cable is...
Collection of links to various places with useful motor information. I’ll try and return to the page every now and again to update it with any motor notes...
If you are working on a large plan, get the real coordinates [latitude, longitude] for two or more points and add them to the drawing. That way you can...
Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.