Fundamental electrical engineering concepts and theory
We have had the Wiki with us for a long time now, but at last I have decided to say bye bye – more details on why below.
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
If you are working on a large plan, get the real coordinates [latitude, longitude] for two or more points and add them to the drawing. That way you can...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
This morning I was explaining how differential protection works to a junior engineer. To give him something to read I opened up the NPAG (Network Protection...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
If two dissimilar metals are touching and an external conducting path exists, corrosion of one the metals can take place. Moisture or other materials...
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.