Fundamental electrical engineering concepts and theory
One of the requirements to ensuring that everything works is to have equipment selected, manufactured and verified [tested] to IEC standards. Not all equipment...
Over the past year or so I've been involved in on going discussions related to referring fault levels from the secondary of a transformer to the primary...
Our IEE cable sizing was wrote a few years ago and had become rough around the edges. I thought it was time to give the tool a service. Unfortunately when...
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
A fundamental concept behind the operation of alternating current systems is that voltage and current waveforms will be sinusoidal – a Sine Wave. This...
Current transformers (CTs) are used to convert high level currents to a smaller more reasonable level for use as inputs to protection relays and metering...
Problems on achieving maximum voltage drop within an installation come up often. Depending where you live, local regulations will have different limits...
For the past few years I have reading eBooks on my HTC touch phone. On and off I have debated buying an eReader and recently purchased a Sony PRS-300 ...
I was reminded of Occam's Razor while reading a book. It's quite a simple principal of logic which has stood the test of time and is accepted as central...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.