Fundamental electrical engineering concepts and theory
Alternating current (a.c.) is the backbone of modern electrical power distribution. In this article I’ll be pulling some of the more important concepts...
This morning I was explaining how differential protection works to a junior engineer. To give him something to read I opened up the NPAG (Network Protection...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
While there are a vast array of cable insulation materials, these are often divided into two general types; Thermoplastic or Thermosetting. For example...
Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...
Three phase systems are derived from three separate windings, either connected in delta or star (wye). Each winding can be treated separately, leading...
IEC 60947 is the circuit breaker standard and covers the marking of breakers in detail. Any manufacturer following this standard should comply with the...
Electrical engineering has a multitude of laws and theorems. It is fair to say the Ohm's Law is one of the more widely known; it not the most known. Developed...
I think this post is going to be helpful to several of our readers. While the IEC low voltage circuit breaker Standard [IEC 60947-2, Low voltage switchgear...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.