Fundamental electrical engineering concepts and theory
Induction motors are frequently used in both industrial and domestic applications. Within the induction motor, an electrical current in the rotor is induced...
Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
In the previous note we looked at the approach taken by the standard to the sizing of cables and illustrated this with an example. We then looked at one...
When looking at the design of a lighting scheme it is useful to have an understanding on the nature of light itself and some of the basic theory associated...
IEC 60947 is the circuit breaker standard and covers the marking of breakers in detail. Any manufacturer following this standard should comply with the...
This is the first of two posts on the resistance of conductors. In the next post I will look at the ac resistance, including skin effect and we deal with...
Straight forward list of some common motor faults. If I have missed any other common faults, please take a bit of time to add them in as a comment below...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
Low voltage (LV) switchrooms are common across all industries and one of the more common spatial requirements which need to be designed into a project...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.