Power systems theory - generation, transmissions and distribution
The IET site has a video of a visit showing of a high tech meeting room developed at Napier University in Edinburgh. It a good demonstration of innovative...
Induction motors are frequently used in both industrial and domestic applications. Within the induction motor, an electrical current in the rotor is induced...
Battery powered cars are a hot topic and widely debated. The pros, cons, issues and time frames can be talked about endlessly. An article by the Telegraph...
The other day I came across an article in Technology Review on the development of a smart transformer. A professor at North Carolina State University is...
Our IEE cable sizing was wrote a few years ago and had become rough around the edges. I thought it was time to give the tool a service. Unfortunately when...
I received this question by email a few weeks. First thoughts was that it is a product of the mathematics of rotating a straight conductor in a magnetic...
A battery consists of one or more cells, each of which use stored chemical energy to produce electrical energy, There are many types of cells and these...
Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.