Power systems theory - generation, transmissions and distribution
The new standard IEC 61439 replaces the old 60439. Compared to the old standard, the new 61439 is a more clearly defined and takes into account the assembly...
Working in the vicinity of electrical equipment poses an hazard. In addition to electric shock hazard, fault currents passing through air causes Arc Flash...
Within Europe the European Committee for Electrotechnical Standardization (CENELEC) has standardised the both the designation and colour of cables. ...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
The mobile phone was born in 1973. They were the size of a brick and weighed a couple of kg, making them difficult to fit into your pocket. At a few thousand...
Our IEE cable sizing was wrote a few years ago and had become rough around the edges. I thought it was time to give the tool a service. Unfortunately when...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
A UPS is an uninterruptible power supply. It is a device which maintains a continuous supply of electrical power, even in the event of failure of the...
Fire resistant and fire retardant cable sheaths are design to resist combustion and limit the propagation of flames. Low smokes cables have a sheath designed...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.