Electrical and related buildings technology
In an earlier note on the site [Photovoltaic (PV) - Electrical Calculations], the theory of solar (PV) cell calculations was introduced. In particular...
A quick post in connection with an email question: Live Tank - the circuit breaker the switching unit is located in an insulator bushing which is live...
A frequent problem in fault calculations is the obtaining of equipment parameters. While it is always preferable to use the actual parameters of the equipment...
Power factor is the ratio between the real power (P in kW) and apparent power (S in kVA) drawn by an electrical load. The reactive power (Q in kVAr)...
A single phase system is perhaps the most common type of system most people are familiar with. This is what people have in their homes and what appliances...
Per unit fault calculations is a method whereby system impedances and quantities are normalised across different voltage levels to a common base. By removing...
Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
Collection of links to various places with useful motor information. I’ll try and return to the page every now and again to update it with any motor notes...
Carrying out a protection system discrimination study is critical to ensure the correct functioning of the electrical system in the event of faults. ...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.