Electrical and related buildings technology
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
In a previous article I looked at the dc resistance of conductors and in this article we turn our attention to ac resistance. If you have not read the...
Within Europe the European Committee for Electrotechnical Standardization (CENELEC) has standardised the both the designation and colour of cables. ...
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
In 2011, with the introduction of it’s Panda search ranking algorithms, Google introduced tools for determining the original author of posts. The intention...
Battery powered cars are a hot topic and widely debated. The pros, cons, issues and time frames can be talked about endlessly. An article by the Telegraph...
"I can live with doubt and uncertainty and not knowing. I think it is much more interesting to live not knowing than to have answers that might be wrong...
When sizing cables, the heat generated by losses within any sheath or armour need to be evaluated. When significant, it becomes a factor to be considered...
Fire resistant and fire retardant cable sheaths are design to resist combustion and limit the propagation of flames. Low smokes cables have a sheath designed...
Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.