Electrical and related buildings technology
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
When looking at the design of a lighting scheme it is useful to have an understanding on the nature of light itself and some of the basic theory associated...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
A load flow study is the analysis of an electrical network carried out by an electrical engineer. The purpose is to understand how power flows around...
Cable insulation is used to provide electrical separation between conductors of a cable. During the historical development of cables, numerous types...
ABB has produced a range of technical guides that offer concise explanations of the major technologies and technical issues in low voltage AC drives. ...
In 2011, with the introduction of it’s Panda search ranking algorithms, Google introduced tools for determining the original author of posts. The intention...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.