Electrical and related buildings technology
Our cable sizing tool is one of the more popular tools on the site. The tool enables cables to be sized in compliance with BS 7671 (the IEE Wiring Regulations...
The other day I was talking to a colleague who is a building services consultant. Despite regularly specifying dry-type/cast resin transformers he was...
myElectrical does not support or promote the use of copyrighted material without the copyright owner's consent. If you believe that material for which...
A lot of our members work in countries where PPE (personal protective equipment) is regulated or they work for companies/organizations which take employee...
For unbalance conditions the calculation of fault currents is more complex. One method of dealing with this is symmetrical components. Using symmetrical...
The following tables provide quick order of magnitude fault levels for a a range of typical low voltage situations.
Power factor is the ratio between the real power (P in kW) and apparent power (S in kVA) drawn by an electrical load. The reactive power (Q in kVAr)...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
Electromechanical relays have been the traditional backbone of electrical protection systems. While over recent years these have been replaced by microprocessor...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.