Electrical and related buildings technology
Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
Gauss's Electrical law defines the relation between charge ("Positive" & "Negative") and electric field. The law was initially formulated by Carl Friedrich...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
myElectrical does not support or promote the use of copyrighted material without the copyright owner's consent. If you believe that material for which...
Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
"I can live with doubt and uncertainty and not knowing. I think it is much more interesting to live not knowing than to have answers that might be wrong...
When selecting a cable, the performance of the cable under fault conditions is an important consideration. It is important that calculations be carried...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.