Electrical and related buildings technology
For unbalance conditions the calculation of fault currents is more complex. One method of dealing with this is symmetrical components. Using symmetrical...
When sizing cables, the heat generated by losses within any sheath or armour need to be evaluated. When significant, it becomes a factor to be considered...
The other day I came across an article in Technology Review on the development of a smart transformer. A professor at North Carolina State University is...
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
Cable insulation is used to provide electrical separation between conductors of a cable. During the historical development of cables, numerous types...
The other day I was reading 'Night of the New Magicians' by Mary Pope Osborn with my son. The story is about a young boy and girl who travel back in time...
Over the past year or so I've been involved in on going discussions related to referring fault levels from the secondary of a transformer to the primary...
IEC 60947 is the circuit breaker standard and covers the marking of breakers in detail. Any manufacturer following this standard should comply with the...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
Problems on achieving maximum voltage drop within an installation come up often. Depending where you live, local regulations will have different limits...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.