Electromagnetic compatibility (EMC) is the study of coordinating electromagnetic fields give off equipment, with the withstand (compatibility) of other...
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
Years ago I was told that you should always try to write the best report you can. Many years later I still think on this as one of the better pieces of...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
Depending where in the world you work, you are likely following one of two standards International Electrotechnical Commission (IEC) National...
While not as popular as it once was, frame leakage protection does still have some use in some circumstances. In essence frame leakage is an earth fault...
This post is quick introduction and overview to different railway electrification voltages used in answer to a question sent in via email. While there...
I have been thinking recently that there appears to be less professional integrity around than when I first started my career in electrical engineering...
Some colleagues had an issue earlier in the week on sizing conduits to be cast in concrete for some power cables . It became clear that none of us had...
If you are wondering what happened to our cable notes, the short answer is that we have moved them to myCableEngineering.com. The "Knowledge Base" at...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.