Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...
Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...
In the previous note we looked at the approach taken by the standard to the sizing of cables and illustrated this with an example. We then looked at one...
The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
When selecting a generator, there are inherent limits on the active and reactive power which can be delivered. Generators are normally sized for a certain...
A couple of months ago I came Microsoft's OneNote and downloaded the 60 day free trail. Since then I have been using it regularly and now have a full license...
This morning I was explaining how differential protection works to a junior engineer. To give him something to read I opened up the NPAG (Network Protection...
We have had the Wiki with us for a long time now, but at last I have decided to say bye bye – more details on why below.
Per unit fault calculations is a method whereby system impedances and quantities are normalised across different voltage levels to a common base. By removing...
I was having a conversation the other day about voltage levels. While everyone was in agreement that low voltage was 1000 V and less, there was more confusion...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.