Straight forward list of some common motor faults.  If I have missed any other common faults, please take a bit of time to add them in as a comment below...

If you are wondering what happened to our cable notes, the short answer is that we have moved them to myCableEngineering.com.  The "Knowledge Base" at...

A load flow study is the analysis of an electrical network carried out by an electrical engineer. The purpose is to understand how power flows around...

Our cable sizing tool is one of the more popular tools on the site.  The tool enables cables to be sized in compliance with BS 7671 (the IEE Wiring Regulations...

Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...

IEC 62305 'Protection against lightning' requires a risk assessment be carried out to determine the characteristics of any lightning protection system...

Many questions sent in to the site are in connection with motor starting and in particular star-delta.  For all but the simplest application, there is...

In three phase systems, the use of transformers with three windings (or legs) per side is common.  These three windings are often connected in delta or...

A frequent problem in fault calculations is the obtaining of equipment parameters.  While it is always preferable to use the actual parameters of the equipment...

This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.