Fundamental electrical engineering concepts and theory
If you want to check a circuit is dead (not live), you should always use the three point method. First check a known live circuit, then check the dead...
Traditionally generation of electricity has involved rotating machines to produce alternating sinusoidal voltage and current (a.c. systems). With the development...
Visitors who like to type web address rather then click menus may be interested in how our URL structure works.
Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...
The widely used United Sates standard ANSI/IEEE C37.2 'Electrical Power System Device Function Numbers, Acronyms, and Contact Designations' deals with...
Installation of a UPS can help in reducing problems due to issues with the power supply. A lot of people relate this to nine key issues. Depending on...
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
This morning I was explaining how differential protection works to a junior engineer. To give him something to read I opened up the NPAG (Network Protection...
The fundamental component of any analogue computer is the operational amplifier, or op amp. An operational amplifier (often called an op-amp,) is a high...
This post is quick introduction and overview to different railway electrification voltages used in answer to a question sent in via email. While there...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.