Power systems theory - generation, transmissions and distribution
In the previous note we looked at the approach taken by the standard to the sizing of cables and illustrated this with an example. We then looked at one...
In an earlier note on the site [Photovoltaic (PV) - Electrical Calculations], the theory of solar (PV) cell calculations was introduced. In particular...
Various techniques exist to enable the correct selection of batteries for UPS applications. The procedure described below is one of the more common. ...
"I can live with doubt and uncertainty and not knowing. I think it is much more interesting to live not knowing than to have answers that might be wrong...
In a previous article I looked at the dc resistance of conductors and in this article we turn our attention to ac resistance. If you have not read the...
Low voltage (LV) switchrooms are common across all industries and one of the more common spatial requirements which need to be designed into a project...
A load flow study is the analysis of an electrical network carried out by an electrical engineer. The purpose is to understand how power flows around...
This post is quick introduction and overview to different railway electrification voltages used in answer to a question sent in via email. While there...
Power factor is the ratio between the real power (P in kW) and apparent power (S in kVA) drawn by an electrical load. The reactive power (Q in kVAr)...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.