Power systems theory - generation, transmissions and distribution
The calculation of current in a three phase system has been brought up on our site feedback and is a discussion I seem to get involved in every now and...
The mobile phone was born in 1973. They were the size of a brick and weighed a couple of kg, making them difficult to fit into your pocket. At a few thousand...
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
A fundamental concept behind the operation of alternating current systems is that voltage and current waveforms will be sinusoidal – a Sine Wave. This...
When selecting a generator, there are inherent limits on the active and reactive power which can be delivered. Generators are normally sized for a certain...
Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...
I think this post is going to be helpful to several of our readers. While the IEC low voltage circuit breaker Standard [IEC 60947-2, Low voltage switchgear...
If you at all familiar with programs like office and outlook, then adding and editing posts is pretty straightforward and intuitive. However, there are...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.