Power systems theory - generation, transmissions and distribution
If you are working on a large plan, get the real coordinates [latitude, longitude] for two or more points and add them to the drawing. That way you can...
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
Tapping your forearm or hand with a finger could soon be the way you interact with gadgets. A new technology created by Microsoft and Carnegie Mellon ...
A frequent problem in fault calculations is the obtaining of equipment parameters. While it is always preferable to use the actual parameters of the equipment...
Our IEE cable sizing was wrote a few years ago and had become rough around the edges. I thought it was time to give the tool a service. Unfortunately when...
The image (reproduced from IEC 60909) shows a typical fault in an ac system. From the illustration it can seen that there is an initial dc component ...
Following on from my post on railway electrification voltages, I thought an introduction to traction substations would be a good idea. Traction substations...
While there are a vast array of cable insulation materials, these are often divided into two general types; Thermoplastic or Thermosetting. For example...
The European Union is implementing a voluntary code of practice for participants with the aim of improving the overall efficiency of data centres. As part...
Electrical notes are a collaborative collection of electrical engineering information and educational material. Any registered user can add content. ...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.