Electrical and related buildings technology
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
This is the first of two posts on the resistance of conductors. In the next post I will look at the ac resistance, including skin effect and we deal with...
Traditionally generation of electricity has involved rotating machines to produce alternating sinusoidal voltage and current (a.c. systems). With the development...
Fire resistant and fire retardant cable sheaths are design to resist combustion and limit the propagation of flames. Low smokes cables have a sheath designed...
Insulation on a motor prevents interconnection of windings and the winding to earth. When looking at motors, it is important to understand how the insulation...
Photovoltaic (PV) cells (sometimes called solar cells) convert solar energy into electrical energy. Every year more and more PV systems are installed...
Over the past year or so I've been involved in on going discussions related to referring fault levels from the secondary of a transformer to the primary...
Request to look at induction motor starting time have come up a few times on the site. Hopefully in this post, I give you guys some idea on how to calculate...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
In an earlier note on the site [Photovoltaic (PV) - Electrical Calculations], the theory of solar (PV) cell calculations was introduced. In particular...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.