The (relatively new) switchgear and control gear standard, IEC 61439 'Low-voltage switchgear and controlgear assemblies' has three methods which can be...
Electrical engineering has a multitude of laws and theorems. It is fair to say the Ohm's Law is one of the more widely known; it not the most known. Developed...
Current transformers (CTs) are used to convert high level currents to a smaller more reasonable level for use as inputs to protection relays and metering...
Years ago I was told that you should always try to write the best report you can. Many years later I still think on this as one of the better pieces of...
Earthing of electrical systems is essential for the correct functioning and the protecting of life and equipment in the event of faults. The earth electrode...
Resistors are electronic components that oppose the flow of current. Manufactured in various types and ranges they have a wide application to electronics...
Before the technical, some general information. E-ink display are found in a lot of e-readers, some mobile phones and similar devices and the intent is...
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
While not as popular as it once was, frame leakage protection does still have some use in some circumstances. In essence frame leakage is an earth fault...
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.