The new standard IEC 61439 replaces the old 60439. Compared to the old standard, the new 61439 is a more clearly defined and takes into account the assembly...
In the previous note we looked at the approach taken by the standard to the sizing of cables and illustrated this with an example. We then looked at one...
Electrical engineering is a field that covers a wide variety of sub-fields, including electricity and electronics. It is a field that goes back to the...
Dielectrics (insulating materials for example) when subjected to a varying electric field, will have some energy loss. The varying electric field causes...
A single phase system is perhaps the most common type of system most people are familiar with. This is what people have in their homes and what appliances...
In three phase systems, the use of transformers with three windings (or legs) per side is common. These three windings are often connected in delta or...
Within Europe the European Committee for Electrotechnical Standardization (CENELEC) has standardised the both the designation and colour of cables. ...
When sizing cables, the heat generated by losses within any sheath or armour need to be evaluated. When significant, it becomes a factor to be considered...
Our cable sizing tool is one of the more popular tools on the site. The tool enables cables to be sized in compliance with BS 7671 (the IEE Wiring Regulations...
I was having a conversation the other day about voltage levels. While everyone was in agreement that low voltage was 1000 V and less, there was more confusion...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.