Questions - Reputation and Privilege 

By on

meQuestions
myElectrical Questions
Our question and answer system while letting you do exactly what it says, is much more. It is a dynamic user driven system, where our users not only ask and answer questions, but can manage the way the system works. This is geared around reputation and privileges.

By taking part in our questions - either by asking or answering, helping manage tags, or several other activities you will gain reputation.  You can also gain reputation by other users voting for you questions and answers. On the flip side your reputation can be decreased - for example by having a question or answer down voted.

As your reputation grows, you privileges also grow.  Early privileges include removing time restrictions between posts and being able to flag/vote on posts.  As your reputation continues to grow your privileges continue grow until you become a trusted user with all  the same rights as a full moderator.  Users who reach trusted status will be highly valued by the site.

Tip: to see what privileges you have, what you can do with them and what additional ones you will soon achieve - once logged in you can click the ‘Privileges’ link under your dashboard on our questions page.

Warning: you need at least one reputation point to post.  Users who drop below this will no longer be able to contribute.

We think the questions and answer system is dynamic and interesting.  Hope you do as well and now is the best time to start building reputation. 

Visit our questions and start to contribute..



Steven McFadyen's avatar Steven McFadyen

Steven has over twenty five years experience working on some of the largest construction projects. He has a deep technical understanding of electrical engineering and is keen to share this knowledge. About the author

myElectrical Engineering

comments powered by Disqus



Autonomous Vehicle Challenge

Two driverless and solar power vans have departed from Italy on their way to China via the silk road. During the 13,000 kM trip the vans will drive themselves...

Back to basics - the Watt (or kW)

When thinking about watts (W) or kilowatt (kW = 1000 W) it can be useful too keep in mind the fundamental ideas behind the unit. Watt is not a pure electrical...

Variable Frequency Drive

Variable frequency drives are widely used to control the speed of ac motors.  This note looks at the mechanisms which enable drive units to control the...

Are We Losing Professional Integrity

I have been thinking recently that there appears to be less professional integrity around than when I first started my career in electrical engineering...

Battery Cars A to Z

Battery powered cars are a hot topic and widely debated. The pros, cons, issues and time frames can be talked about endlessly. An article by the Telegraph...

DC Motor Operation

Coils of wire on the rotor carry a d.c. current which generates a magnetic field. A stator magnetic field is created using either permanent magnets or...

IEC 60287 Current Capacity of Cables - An Introduction

IEC 60287 "Calculation of the continuous current rating of cables (100% load factor)" is the International Standard which defines the procedures and equations...

Battery Sizing

This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.

Thermoplastic and Thermosetting Insulation

While there are a vast array of cable insulation materials, these are often divided into two general types; Thermoplastic or Thermosetting. For example...

Understanding LV Circuit Breaker Fault Ratings

I think this post is going to be helpful to several of our readers. While the IEC low voltage circuit breaker Standard [IEC 60947-2, Low voltage switchgear...

Have some knowledge to share

If you have some expert knowledge or experience, why not consider sharing this with our community.  

By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.

To get started and understand our policy, you can read our How to Write an Electrical Note