Fundamental electrical engineering concepts and theory
The new standard IEC 61439 replaces the old 60439. Compared to the old standard, the new 61439 is a more clearly defined and takes into account the assembly...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
The following tables provide quick order of magnitude fault levels for a a range of typical low voltage situations.
In an earlier note on the site [Photovoltaic (PV) - Electrical Calculations], the theory of solar (PV) cell calculations was introduced. In particular...
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
Dielectrics (insulating materials for example) when subjected to a varying electric field, will have some energy loss. The varying electric field causes...
Multimeters are undoubtedly the most common item of electrical test equipment in use. Often it is the first piece of equipment people will turn to when...
This morning I was explaining how differential protection works to a junior engineer. To give him something to read I opened up the NPAG (Network Protection...
Electrical notes are a collaborative collection of electrical engineering information and educational material. Any registered user can add content. ...
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.