Power systems theory - generation, transmissions and distribution
The following tables provide quick order of magnitude fault levels for a a range of typical low voltage situations.
We have had the Wiki with us for a long time now, but at last I have decided to say bye bye – more details on why below.
One of the comments on my Motor Starting Series was asking for something on duty cycles. Here it is. As a purchaser of a motor, you have responsibility...
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
Induction motors are frequently used in both industrial and domestic applications. Within the induction motor, an electrical current in the rotor is induced...
Traditionally generation of electricity has involved rotating machines to produce alternating sinusoidal voltage and current (a.c. systems). With the development...
Using software in our work is essential for most of us and we are becoming even more dependant on it's use. While software is a great asset, many times...
It wasn't so long ago I was telling someone that I don't use rules of thumb as most things are easily calculated anyhow. As it turns out I last week...
Electromechanical relays have been the traditional backbone of electrical protection systems. While over recent years these have been replaced by microprocessor...
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.