Electrical equipment - design, use and implementation
This article gives an introduction to IEEE 485 method for the selection and calculation of battery capacity.
If you are wondering what happened to our cable notes, the short answer is that we have moved them to myCableEngineering.com. The "Knowledge Base" at...
Electromechanical relays have been the traditional backbone of electrical protection systems. While over recent years these have been replaced by microprocessor...
The other day I came across an article in Technology Review on the development of a smart transformer. A professor at North Carolina State University is...
Our IEE cable sizing was wrote a few years ago and had become rough around the edges. I thought it was time to give the tool a service. Unfortunately when...
This is the second post in a series of two on periodic electrical inspections. In the first post, I discussed how often inspections should be carried out...
The International System of Units (abbreviated SI) is the world's most widely used system of units. The system consists of a set of units and prefixes...
IEC 60228 is the International Electrotechnical Commission's international standard on conductors of insulated cables. Among other things, it defines a...
IEC 60287 "Calculation of the continuous current rating of cables (100% load factor)" is the International Standard which defines the procedures and equations...
Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...
If you have some expert knowledge or experience, why not consider sharing this with our community.
By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.
To get started and understand our policy, you can read our How to Write an Electrical Note.