Thermoplastic and Thermosetting Insulation 

By on

While there are a vast array of cable insulation materials, these are often divided into two general  types;  Thermoplastic or  Thermosetting.   For example the current capacity determination of a cable in accordance with  the UK Wiring Regulations is categorized into thermoplastic and thermosetting cables.

Thermoplastic materials are composed of chains of  molecules (polyethylene for example).  When heat is applied the energy will allow the bonds to separate and the material can flow (melt) and be reformed.

Thermosetting materials are formed when materials such as polyethylene undergo specific heating or chemical processes. During this process the individual chains become cross linked by smaller molecules making a rigid structure.    Thermosetting materials cannot reheated, melted and remolded.

While thermoplastic materials have the advantage of being able to be reformed, thermosetting materials are generally more heat resistance and have greater strength.

The operating temperature of any cable is an important parameter in determining the maximum allowable current.   While the actual temperature varies depending on the material used, the UK Wiring Regulations limits the choice in calculating the current rating to two temperatures only:

  • Thermplastic 70 0C
  • Thermosetting 90 oC

Note: more specific calculations based on actual material properties are allowed.  However, for ease of use most practical application will use 70 oC or 90 oC and the methods outlined in the regulations.

See Also



Steven McFadyen's avatar Steven McFadyen

Steven has over twenty five years experience working on some of the largest construction projects. He has a deep technical understanding of electrical engineering and is keen to share this knowledge. About the author

myElectrical Engineering

comments powered by Disqus



IEC Document Designation

Often document control is dictated by project requirements, for example a particular organisation may have an existing numbering system. Existing company...

Fire Resistant and Fire Retardant Cables

Fire resistant and fire retardant cable sheaths are design to resist combustion and limit the propagation of flames. Low smokes cables have a sheath designed...

Michael Faraday (the father of electrical engineering)

Famed English chemist and physicist Michael Faraday was born on September 22, 1791, in Newington Butts, a suburb of Surrey just south of the London Bridge...

EU Code of Conduct on Data Centres - Best Practices

The European Union is implementing a voluntary code of practice for participants with the aim of improving the overall efficiency of data centres. As part...

IEC Reference Designations

The IEC publishes a series of documents and rules governing the preparation of documents, drawings and the referencing of equipment.   Depending on country...

What are you reading!

Reading is a bit of a hobby of mine and I"ve done a few off-topic posts in the past on this. Rather than continue doing the occasional post I thought ...

Variable Frequency Drive

Variable frequency drives are widely used to control the speed of ac motors.  This note looks at the mechanisms which enable drive units to control the...

Questions - Reputation and Privilege

Our question and answer system while letting you do exactly what it says, is much more.  It is a dynamic user driven system, where our users not only ask...

DC Component of Asymmetrical Faults

The image (reproduced from IEC 60909) shows a typical fault in an ac system.  From the illustration it can seen that there is an initial dc component ...

How to refer fault levels across a transformer

Over the past year or so I've been involved in on going discussions related to referring fault levels from the secondary of a transformer to the primary...

Have some knowledge to share

If you have some expert knowledge or experience, why not consider sharing this with our community.  

By writing an electrical note, you will be educating our users and at the same time promoting your expertise within the engineering community.

To get started and understand our policy, you can read our How to Write an Electrical Note